Search results

  1. B

    Flite Dek 180 Tach operation

    I have my tach wires as hooked per spec. They are hooked to my p leads on a 0320 lycoming. I also installed the 30 k resistors as shown in book. I noticed when I was spinning up my motor for the first time to pre oil that my tach was junping from 0 to 5186 or something like that. I did not have...
  2. B

    fuel flow totalizer

    While installing my new flitedek 180 I also had a fuel flow gizmo that a card attached to it with numbers on it. After reading the installation guide I put this card away where I could input the values later. Well I have misplaced it and now I was wondering is there a default value I can start from?
Top