Search results

I am experiencing a bizarre problem. Usually following start-up, when I press on the “map” key, then the “direct” button, the screen shows the last dozen or so destinations that I previously went “direct” to. But that does not happen anymore. Instead the screen shows only two destinations—one...

I am experiencing a ADAHRS error, which reads “Disabled: Internal Error - Multiple Sensors” I have a dual classic screen set-up, with only a single ADAHRS, and the error only shows on one of the screens (screen 2). The main screen (screen 1), shows that the ADAHRS is “enabled”. This is the...

I have dual Dynon Classics, with Winds Aloft and X Wind shown in the bottom left. It almost always shows 99 for both the magnitude of the wind and the cross wind component (see attached picture). Is this a compass calibration issue? Or is something else causing the problem? Thanks in advance.

Can folks share the process for correcting the RSOD. I have two Dynon Classics installed, and today the pilot screen flickered and then went to the RSOD. Scary. I tried cycling the power with the buttons and then with a manual switch, the screen would not boot and I would only get colored...

I am new to Dynon. But, trying to understand how the system figures out the ranges (and names) for both the MAP and TACH/RPM sensors. When I view the User_Config file, and look within the "ems1 ={", the definitions for MAP and TACH/RPM are confusing: 1) With respect to the MAP definition (and...