Search results

Hi Folks, I have wired my ACS A-510-2 starter switch to the VPX as prescribed PWR pin to jumper J10-1 and the starter annunciator with a 1K 1W resistor in line to pin J2-11 When checking in VPX configurator, I can see the starter on message in device status going to ON when cranking to the...

I have a small question on wiring the optional Broken-Line detection for the autopilot disconnect switch on my G407 stick. My appologies upfront for the stupid question, I'm not very skilled in electronics or electricity. Although so far I have been lucky not to see any smoke. The manual...

hi Everyone, I have a small question (probably stupid). I'm wondering why the manual on the install kits of roll and pitch servo tell you to drill a #11 size hole in the bellcranks. Is there a reason why this is #11 ? In the entire aircraft I have always drilled and reamed #12 holes for AN3...

Hi all, I am planning on buying the SV-HARNESS-INT harnass for the intercom as it seems too many wires to handle conveniently by myself. The manual of the intercom states about ground loops and shield grounding : Because other electrical loads can cause large current flows in a ground path...

(updated after response1) Hi, I have a small question on the connection of the VPX serial data connection to the D37 harnass. I'm not very confident with wiring yet and feeling better safe than sorry and asking upfront to this wise community. I read in the VPX manual that you can pick any...

Hi, I'm new to dynon, got all my hardware and starting to install my skyview system. The manual says to install brass hardware on the adahrs box installation. I could find brass screws on aircraftspruce but I have been looking like crazy for brass nuts and washers but can't find them. How did...