Search results

I am wondering if others are experiencing WiFi dropping on their HDX Systems? Background: I have a dual screen HDX system (yes I have both WiFI dongles installed) that I have been flying behind for almost five years and 700 hours. I have on occasion had problems where the wifi connection...

I had a discussion yesterday with a fellow pilot who uses a Skyview Touch in his RV-12. I have an HDX (2 Screens) in my VFR experimental Zenith, I also carry an IPad with Foreflight. I was under the impression that I needed a subscription to a Chart Data service in order to have my Dynon maps...

My Dynon HDX (latest SW version 16.7.0 has been installed) just started to give me the warning that the BU Battery needs to be tested (I did it about 6 months ago and it passed). Problem is that when I pressed the Test Battery button (did this several times) the Dynon just rebooted and gave me...

Is there somewhere on the Dynon site to download a copy of the older Skyview Installation Guides? Reason, my Dynon System has the EMS 220 and all the new guides refer to the EMS 221. l have a non-CANBUS UL Power engine with EMS 220 and the installation and configuration section of the online...

I have a Dynon HDX system in my Zenith, I am flying behind a UL Power 350is and I don't have the Red Cubes. I know that the Dynon system will measure FF without the Red Cubes as long as I input a "K" Factor based on my actual GPH. Here is my issue, in the Hardware settings I have required...

I have a dual screen Dynon HDX system with Dynon Pitot, ADAHRS, etc. I have been flying this system for 3 years and during that time I have always had a erratic or bouncy airspeed indication (2-3 MPH up and down) while in flight. I have done all the calibration that I can with this system, in...

I have a Dynon HDX Panel in my experimental with Dynon Radio and Intercom. I am having a problem with the audio on the co-pilot side. Intercom between the Pilot and Co-pilot are great and on the Pilot side has the radio transmit and receive are excellent. I have had several different...

I just noticed that there is "another" firmware release on the Dynon website. Does this fix any issues from the v 16.0.1?

I have a dual Dynon HDX screen system with Dynon Autopilot, Dynon Radio, Dynon Audiopanel and Dynon Knob Panel. The sound is fine until I reach out to touch the screen and then I get "static" which immediately goes away when I move my hand away. Any idea why this happens? And how can I fix or...

I have an HDX system with Dynon 42 (Roll and Pitch) Servos installed on my Zenith CH-750 Cruzer. The system has the latest software version installed and I typically run it in simplified mode as I only fly VFR. Whenever I engage the autopilot (especially in smooth air) it tends to start...

When is Dynon (Kirk) going to do some updated training videos specifically on the HDX system?

I have a Dynon HDX system (without the Red Cubes). My setup shows a K factor for both fuel flow to and return input setting in order to determine the Fuel Flow for the display. I know that the engine fuel flow formula is: 1. 48 l/h = 12.68 gallons / hr 2. 170 pulses / sec = 612,000 pulses /...

I have a UL 350is and my Dynon HDX does not have a setup for that motor so I just used the "other" engine. My question resolves around fuel flow pulses. The "other" engine setting defaults the feed and return fuel flows at 68000 pulses per second. I have calculated the UL Power pulses based...

Just setup my Dynon HDX and we noticed that the audio alerts are not heard in the copilot headset. Is this normal? If not how do I fix it?