Search results

I have been trying to get a combined CHT/EGT graph displayed across the bottom of the display. I can't figure out how to do this. Does anyone have a Rotax 912ULS with the combined display? I am beginning to think this is not a supported widget for the Rotax. I have 4 EGT probes on the...

I have 4 EGT probes, one for each cylinder. I have labeled these in the setup as EGT1, EGT2, EGT3, and EGT4. I see the 4 EGT readings on the graph, but the cylinder numbers are not displayed--only 4 numbers at the bottom of the bar graph. All 4 read 75 degrees F (correct). Should the "1"...

I'm in the hangar (no satellites are visible). How can I tell if my SV-GPS-2020 is communicating on the network? The SV-GPS-2020 does not appear in the list of detected devices (but there is a disclaimer about the SV-GPS-245). I was looking for a screen that might say something like...

I have a different ammeter shunt than the one supplied by Dynon, so I need to edit my Sensor Config File to change the c_X1 constant. I have the downloaded "duc" software file on my desktop computer. Does the software update need to be installed on the HDX system and then the Sensor Config...

I have a new HDX System just upgraded to the new version 17 software. I have only had the system powered up for a few days. I wanted to setup the wi-fi feature, but the displays are not recognizing the Dynon wi-fi adapters plugged into a USB jack on each display (2 adapters, one plugged in to...

One of my fellow builders told me that the Skyview system with a backup battery can be powered up without turning on the avionics master switch. This would be done to observe engine data (e.g. oil pressure) at startup before turning on the avionics master. I think he said that you can...

I have been researching the dimming operation of the Skyview HDX system and I keep finding differing opinions on how it works. Dynon has told me different things... Does anybody really know how the dimming circuits work? For example, I have a two-display system. Is it possible (without using...

I bought and installed a remote magnetomer in my wing but I am probably 2 years away from buying the rest of the avionics. I wondered if it would be possible to connect power to the magnetomer and look at the RS-232 communications over the network cable? Does Dynon publish details on how...

I am planning to buy the unheated AOA/Pitot Probe (#100141-000 ). It requires a mounting bracket. I noticed on the Dynon website that they offer Builder Support Products. There is a Pitot Mount Bracket for the VANS aircraft. Would this bracket work for the RANS S-19 Venterra? Is the...