Search results

Re: Trim widget problem follow on Just to confirm I did everything right I went back to EMS SETUP / SENSOR INPUT MAPPING / C37-P4 I changed the designations to CONTACT / CONTACT / CANOPY and at that point the screen layout editor had a CANOPY designation and I was able to install a widget from...

Hi Guys, I have installed three RAC servos on my aircraft to operate the Aileron Elevator and Rudder trim. I have the Elevator and Rudder reporting through my VP box (since it only supports two axis) and the Aileron is managed independently by an Infinity Aero board and reports through my EMS...

I am installing the Garmin GTN 750 with a Skyview system. Both companies make a compatible transponder. Anyone with any knoweledge on the subject care to suggest which one would be best? Mounting location, proximity to antenna, and associated avionics are not a problem. Thanks, Bryan

I am planning on the 7" Skyview system and a Garmin GTN 750. The question is: Can I use a single Garmin antenna to run both systems (or the other way around) will the Dynon antenna run both the Skyview and Garmin units?  The Dynon antenna has an advantage in that it is powered from the Dynon...

Hey Dynon guys... How much trouble would it be to have a taxi sub or imbedded screen display in this new unit? We could then install one of those inexpensive mini cam's under the nose of the aircraft so we could better see where we were taxiing. You could (push button) swap out the nav display...

Yes. wires from the end of the controller would have been a porblem

Hey Dynon guys... For us in the planning stages could you update your install specifications manual to show where the wires exit the heater controller box? Additionally could you specify how long the wires run from the box to their connectors and then from the pitot connectors to the pitot...

If I run your new unit on 28v will there be a port or LRU to supply 12v for the Dynon heated pitot or RAC trim servos ?, or will the heated pitot come in a future 28v version, or will I need an aftermarket converter box... gotta love this new Dynon stuff!

Say whats the chance you will eventually build an LRU for the new Dynon product that is a gear retract fail safe switch based on airspeed?

Will this new unit support additional engine monitoring inputs? I need coolant temp and pressure displayed... Thanks