Search results

VFR Flight today. I took off with the Skyview HDX screen displaying my transponder was squawking 1200. Approaching an airport the tower asked me to Ident. I tapped the 1200 on the top of the screen to bring up the transponder interface and nothing happened. I then brought up the dashboard...

Greetings, I experienced a System event 20 today on completion of installing HDX update 16.7.0 I use a wifi dongle I have a 915is configured as "other" in the HDX setup without Dynon EMS and a Kanardia Digi for engine instrumentation.

I’m going to fly with it in the other plane and see if the problem shows up there, before returning it.

A Google search states they have a 5 year warranty, so sh be so. We’ll see.

I’m back from flying today and here’s what I found out. I removed the A20 headset I have been using and the problem went away. Useing an older bose aviation X headset and my voice sounds clear when transmitting. Useing the A20 from my other aircraft and no problem either. This and a poping...

The LHS has a plug about 3 inches from the device that can be disconnected. The wires to the intercom and power and ground are less than 4 feet in length. I never connected the data feed to the Skyview. I obtained the power from tapping into an accessory electrical outlet used to power the...

The landing height system, has multiple wires, an audio shielded, a power shielded, a ground and a data, for gps input. It uses LIDAR for measurement. Would simply turning off the intercom rule out the connections to it as a source? It is an aircraft that’s almost a year old. I’ve lived with...

Thank you for all that information. I do have a landing height system with shielded audio wire connected to the pin 17 of a SV-intercom-2S. The shield Is grounded to pin 1. The power wire for the LHS is also shielded, but the shield isn’t grounded. The only time noise is heard is when PTT is...

Maybe I have the X83 instead of the X25. There doesn’t appear to be an external visible difference. The set up picture I posted above indicates 8.33 kHz frequency spacing. Am I correct in interpreting your statement that mic gain is on the X25, but not the X83? If it is on the X83 too, do...

I would like to add, that the white noise is wholly absent from intercom conversation.

Thanks for the reply. I believe the radio is the SV-Com X25. I only have LEMO jacks and I haven’t tried other headsets. What I’m experiencing is white noise simultaneous with the sound of my voice when transmitting, but not when the cabin is quiet, i.e. Engine not running, on the ground...

When I press push to talk and transmit the side tone picks up my voice and white noise, that I think may be environmental. I’m wondering if turning down the microphone gain would help, but in the com setup, mic gain is greyed out and can’t be adjusted. When the motor isn’t running, the white...

Thanks for the response. It was good information and worked to fix the issue.

I have a Skyview HDX 11 in a Magni Gyro with 915is engine. It has a Kankardia EMIS. After installation of the 16.5.2. update package the Skyview Flashes a warning light Caution in yellow. When selected, the the button displays Can Failure. I'm guessing this is because I don't have the Dynon...

I’m using the hdx in my gyro and I’d like to upgrade my Mooney panel with one too. But, the Mooney will need an autopilot solution.

I’m having this problem too. I’ve already spent time and money trying to resolve it before stumbling on this thread. My ForeFlight log book enters are incomplete due to the dropped connections. I had a SureFly EIS in my plane. It would shutdown repeatedly in flight. It was interpreting the...