Search results

I'll do some checking tomorrow. I don't think it is connected or share with anything else. My panel and wiring are pretty simple.....but I did the work myself, so might not be perfect.

well I haven't flown yet, but it appears that didn't work. Installed a new sensor and the readings on the ground are unchanged. Is there anything else I should be checking or doing?

OK thanks. I'll get one ordered and swap it out during my condition inspection next month. I've had this one about 4.5yrs or so...might be out of warranty. ;)

Here's my numbers at 29.92 this morning in the hangar. And this was roughly field elevation when I first powered it up. 27.50 is as low as I can go with the Baro...is this correct? Looks like I do have a error.  Can it be fixed with a new sensor or ???

3893' is field elevation. Probably closer to 3894 or 95 at the hangar.  I'll be out there again tomorrow. Earlier I snapped this pic after I ran it back up to make sure it was still moving and not bottomed out(if that's possible)

Thanks I went to the hangar today and checked it. I couldn't lower the Altitude to 0. Lowest I could achieve was 1400' and 27.40 baro reading. I assume that if I was able to reach 0 altitude, I would be 26.00inhg...Is that a correct assumption? I was showing MP of 26.4", so will guess I...

ok thanks. is there an adjustment procedure to fix it?

How do I check to ensure my manifold pressure reading is correct.  I have RamAir on my RV-7 and it almost always reads higher than other planes. One "expert"   ;)  says no way my MP readings can be as high as it is. I see 21.5" at 10500 (11500DA) and around 23.7 at 8500'. Am I offbase here or...

Operator error all the way. I pushed the right buttons and tada it works!

It's hooked to the EDC. I'll set the type to #2 and check the other stuff tomorrow. Thanks I figure its more of an operator issue than any real problem

I've just started flying my newly completed RV-7. I have a D180 and remote compass with OAT. The compass is giving input to the D180, but I can't seem to get OAT to show up on the screen.  I have select type 1 probe, but get a message that says not found (or something like that). D180 & EDC-10a...

so will these trade-in units, be resold to some of us poor folk. ;)