Search results

  1. R

    EGT CHT readings false on #1 cylinder

    CHT and EGT Probes labels of Cylinder 1 were inverted
  2. R

    Capacitent fuel probe to Dynon HDX issues

    Issue resolved One wire bad connection ( swapped carburetor temp and fuel gauge) , and an other one mis-attached Thanks
  3. R

    Capacitent fuel probe to Dynon HDX issues

    Do you mean sending 12V directly in capacitance plates?
  4. R

    Capacitent fuel probe to Dynon HDX issues

    Do I have to declare capacitance plates as resistor senders in EMS configuration, and not capacitance, as I use dynon converters?
  5. R

    EGT CHT readings false on #1 cylinder

    That is right EGT and CHT EMS harnesses are labelled
  6. R

    Capacitent fuel probe to Dynon HDX issues

    Hello all, What about Van's capacitance plates? I installed them on both reservoirs, and installed Dynon capacitance converters, bus both calibration failed ( no voltage shown) Any idea?
  7. R

    EGT CHT readings false on #1 cylinder

    Be aware that sometimes Dynon inverts EGT and CHT probe labels...check wires colors instead:D That was the issue....
  8. R

    EGT CHT readings false on #1 cylinder

    Hello All, Before starting, all EGT are reading OAT, but after starting, #1 cylinder shows red cross on CHT and a false reading on EGT, very lower than the others Checked connections, ane discrepancy is still here Any idea?
  9. R

    TX mode loosed on SV-Com T8 and SV-intercom-2S

    Sorry for inconvenience... one PTT was short circuited All is OK Have a good day
  10. R

    TX mode loosed on SV-Com T8 and SV-intercom-2S

    After review of installation manual, it appears that orange led is ON when transmit on my intercom, it remains always orange after starting the system.....
  11. R

    TX mode loosed on SV-Com T8 and SV-intercom-2S

    Hello all, We are facing this issue on brand new RV-7 Last week, master switch has been let "ON" all the week end and main battery has been fully discharged After recharging battery, and switched ON all the systems, it appears that we have loosed any TX function on radio and intercom, as both...
  12. R

    Autopilot slow roll in flight

    Hello Sometimes in flight my autopilot seems to make a light roll right and left ( dutch roll?) Any idea? Thanks
  13. R

    180 hold button

    Hello all. On my D10A this fonction is very helpfull. Dors it work also on skyview?
  14. R

    Flap position delete on HDX screen

    Hello Can we delete unused flap position indicator on HDX display?
  15. R

    High RPM withour engine running

    Thank you for replies When moving engine by hand, discrepancy disappears Have a good day
  16. R

    High RPM withour engine running

    Hello everyone I have this issue with HDX 1000 and Pmags installed, since I have wired them: with main battery ON, and Pmags ON, engine not running, EFIS shows 10300 RPM !! I put diode on both Pmags Any idea? Thanks in advance
Top