Search results

Re: Software 5.4 for EFIS D10 A on an MCR01 Sporst OK, thanks for your reply, I am waiting for the follow up of my demand by direct email. KR Francfi

Re: Software 5.4 for EFIS D10 A on an MCR01 Sporst Att Dynon Support. My Package EFIS D10 S/N 5829 EDC D 10 A S/N 7643 AP 74 S/N 1280 2 servos SV 32 S/N 1564 & 1562 My latter in flight settings -Torque 100% Sensitivity 21 Pitch Gain 30 Alt Gain 18 VSI Gain 21 Pull Rate 13 G Error Ga 12 G...

Re: Software 5.4 for EFIS D10 A on an MCR01 Sporst First thanks to D.Brown for his smart comments and suggestions Attention Dynon Support I have now the following settings with 5.4 Torque 85% Sensitivity 25 Pitch Gain 30 Alt gain 13 VSI Gain 25 Pull Rate 16 G Ga 13 G lim 25 and the...

Re: Software 5.4 for EFIS D10 A on an MCR01 Sporst Att Dynon Support, I am still uneasy with the 5.4 firmware which is not delivering the same good and simple control of pitch as the 5.3 did. Having got back a 5.3 firmware from an other Dynon client ( by email) , I have tried so far...

Re: Software 5.4 for EFIS D10 A on an MCR01 Sporst Thanks for your last message. However I have a question. When setting the Advanced Pitch Gain and Rate Adjustments on default values (for all 6 of them) , as per your AP Installation and Configuration Manual -page 6-20, does the 5.4 firmware...

Re: Software 5.4 for EFIS D10 A on an MCR01 Sporst My settings are: Max speed; 304 km per hour Min speed: 140 km per hour Torque 100 per cent Sensivity 15 VSI 400 ft per min All other settings on default value With previous software , targeted values ( alt and VSI) were reached I would rather...

I have a EFIS D 10A + AP 74 + 2 SV 32 with upgraded 5.4 software Everything is Ok besides; - gap of 30 to 50 ft between prest targeted altitude and rechad one when aircraft levels - preset VSI is 400 ft/mn; actual one during climb or deescent is about 200 to 300 ft/mn Please advice as I did not...