Search results

Ok, I managed to to add another option "ELEV2" - the problem is, when I want to display it, only two styles are available - analog value (between 0 and 5) or FLAPS-like widget (quarter-gauge and needle) but no other styles - so no elevator trim widget (bar with two arrows on each side) is...

that’s exactly what I also found but honestly after trying it - I have no idea how to achieve that. See attached pictures - I don’t have any possibility to create my own sensor input - only use already existing ones and ELEV can be used only once - no chance to add it in “a custom way” :/ Not...

Hi Mike, It’s an official kit - Savannah SR from I.C.P - basically modified zenith 701. It uses two separate trim tabs on aa elevator and therefore two servos. The POH says you should do a full trim cycle before every flight to make sure they are synchronized. I want to monitor both these...

I have two elevator trim servos and I would like to see their position on the HDX display, but it seems I cannot setup it this way (only one trim servo is possible to confirm) - is there any solution/workaround?

Hi, I have Rotax 912iS installed and when I press and hold the Start Power Switch, then Start Switch and if I let go the Start Power Switch in first 10-15 seconds after the start, I get CAN Fault message, both Rotax warning lights (line A and B) are solid and all avionics is running on battery...