Search results

  1. K

    Dynon Checklist Editor

    Tried using the Excel based checklist editor but when I go to save it I get an error screen with a "run-time error". Excel works fine for any other document on my Mac. Tried saving it as a text file and I also get an error message that it cannot save it because it contains multiple pages...
  2. K

    Dynon D180 and new Kavlico Pressure Sensor

    Just replaced my oil and fuel pressure Kavlico sensors with the new P/N 103757 pressure senders per the service bulletin. My D180 oil pressure indications are good, HOWEVER, fuel pressure now shows about 7 psi and 9 psi when the electric boost pump is on. The older Kavlico sensor that I...
  3. K

    HS34 Audio output and SV-Intercom-2S

    I am wiring my SV-Intercom-2S and my HS34 along with my FlightDEK-D180 with AOA.  The HS34 installation shows a voice output at pin number 25 and the FlightDEK-D180 shows an AOA Alert Audio Output at pin number 18 of the DB25 connector.  Page 4-10 tells me that I should only connect the audio...
  4. K

    OAT and D10A compass connection

    Yes, it is the EDC 10A remote compass.  I finally found the reference in the FlightDEK D180 installation manual.  No reference was with the installation instructions for the remote compass or OAT probe. Mike H replied to my e-mail yesterday and said pins 1 and 8 "should be connected inside the...
  5. K

    OAT and D10A compass connection

    I am in the process of closing out the wings on my slow build RV-8. Wiring instructions for the OAT probe state to connect "the blue wire/shield combination to the same ground that feeds the EDC-10 through pin 1." With a D sub connector from the remote mag lead already in the pin 1 location what...
Top