Search results

I'm doing a 2020-compliance hardware and software update for my skyview system. replacing old antenna w/ -2020 and replacing -262 xpdr w/ -261.  I can't find the "download" button for new xpdr software. is it imbedded in system software update? I understand latest is SW02.11. where on dynon site...

Re: posted mortum: OS 13 did not instal when downloading update to my thumb drive i took the drive out before the download was complete (i switched to macbook from win laptop and it's different) i reloaded update using a windows laptop and 13.0.03 installed without a hitch. so the screwup was...

one more

more screenshot

today i tried to load new os 13 and DB. i loaded on first screen (left) and seemed ok. tried on RHS and was not able to instal properly. no AP nor XPDR, etc. frustrated and CX'd flite. seems like firmware problem(?) attached are screen shots. my a/c is 2012 Remos S-LSA and came from factory...

I am having trouble reading the instructions on the skyview screen during calibration/stall. I would like to print them out on paper but can't find them anywhere. Can dynon support pls provide a .pdf or equal?

Yesterday 9.13.2012, I got error red MSGs "oil pres low" & "fuel pres low" again only on left display. This time took pix of entire panel showing error msgs just on left skyview. Round widgets showed pressures in green on both displays so I was not alarmed. Seems like I'm not able to post photos...

I have a new remos GX with twin 7" skyviews. I get a yellow "spd" MSG on top of the screen in the autopilot section when I start my departure roll, and on roll out after landing. Audible BEEP BEEP BEEP too. Beep intervals some times gets more frequent.  Almost as annoying as "pull up"...