Search results

  1. C

    NAV RADIO

    I am waiting since 2010 a DYNON COMM-NAV to install remotely on subpanel...... >:(
  2. C

    Lightspeed EI tach settings?

    I had problems in configuration before when I for mistake upload one wrong file. After that I correct all the parameters of the EMS like FF, MAP, OIL Temp, etc. Since many months ago the values was correct. 3 days ago I flown the aircraft and everything OK. Monday happen this, the RPM's abnormal...
  3. C

    Lightspeed EI tach settings?

    This happen only yesterday. The system have given the correct rpm's since January. Something changed yesterday!!!
  4. C

    Lightspeed EI tach settings?

    Today dynon read 33000 rpms on both screens!!!! the engine was running around 1000 but the reading was absurd! what is the problem? when isolated only the CDI red 0 rpm as always and when isolated the mag only or both the rpm were above 33000!!! was the first time I saw this happen. Any help?
  5. C

    Lightspeed EI tach settings?

    I did not built the airplane, I contacted the builder and he wrote; The Dynon has two sets of wires that monitor the RPM. One is for high voltage - mags and the other is for low voltage - electronic. I used the high voltage lead with a dropping resistor for the left mag. I then used the low...
  6. C

    LOP and ROP

    Thanks for your attention. MP, altitude,OAT and RPM are correct. May be the Fuel flow needs attention. My question is also when you see LOP or ROP we can not quantify in terms of degrees? How LOP and how ROP? :-?
  7. C

    LOP and ROP

    Hi. I have a SV 100 and a SV 70 instaled. On my first flight, on circuit pattern, I red LOP 45%. The numbers means the % of power (180hpX45%) correct? The LOP means a automatic process of leaning. How is possible LOP if I had the mixture full rich? and the EGT were normal? any explanation...
  8. C

    Lightspeed EI tach settings?

    for the tach input into the SV EMS 220 we used the PIN 35 for LSE (R) and PIN 32 for MAG (L) on EMS. When running only on LSE (R) no RPM information on SV
  9. C

    Lightspeed EI tach settings?

    I have a left mag and a right LSE plasma II plus. When I check the left mag the RPM reading is normal, showing 70 RPM drop. When I select R mag (CDI) I get 0 rpm, no information rpm at all. I use the pin 35 (green) Low voltage input for LSE CDI on Right and the pin 32 to the magneto on left...
Top