Search results

  1. S

    Multiple D-10a's and HS34 Wiring

    Thanks, I think I've got it now.
  2. S

    Multiple D-10a's and HS34 Wiring

    I have 2 D-10A's and I will be using one as a Attitude Indicator and the other as an HSI and using an HS34 to interface with my GNC420 and SL-30. In the event of failure of one D-10A or it's power source I wish to have the remaining unit retain as much of the capability as possible by just...
  3. S

    Intermittent HSI screen

    Thanks for the quick resolution. My HS34 is on the way so this was minimum inconvenience for me.
  4. S

    Intermittent HSI screen

    I have the GPS input going to the Bus Master and it works fine. But the the GPS course indicator on the Horizon screen is blinking on and off. Will I be able to eliminate this behavior when I set the system up with the HS34? Thanks.
  5. S

    Intermittent HSI screen

    I have 2 D-10a's that have been upgraded to 4.0 and networked together via DSAB. I have connected my Garmin GPSMAP 195. The GPS is set to NMEA0183 out/no in. The HSI screen on the master D-10a presents the GPS data correctly and as expected. If I select the HSI screen on the slaved D-10a the...
  6. S

    Unheated pitot

    The AOA pitot I posted for sale has been sold.
  7. S

    OAT

    I understand that in a dual D-10A set up I need a separate EDC-D10A for each D-10A. If I already have an OAT sensor can I can I use that one sensor to provide OAT to both EDC-10A's ?
  8. S

    Dynon AOA Pitot Tube

    I have a new Dynon unheated AOA pitot for sale. Best reasonable offer gets it. Please reply offline.
  9. S

    Dynon AOA Pitot Tube

    I have a new Dynon unheated AOA pitot for sale. Best reasonable offer gets it. Please reply offline. stickshker_99@yahoo.com
  10. S

    GNC420 OBS

    Is there a time frame for the availability of the upgrade of the Garmin 420/430 interface.
  11. S

    GNC420 OBS

    Is there something in the works that will allow OBS function on the GNC420/GNS430 to operate as it would if a conventional indicator (i.e KNI520) was installed with a Garmin GNC420 , SL-30? In a dual D10A installation does the info from the EDC-D10A flow through the DSAB to be shared by both...
  12. S

    EDC D10 Mounting

    If I mount the remote compass sensor on the rear deck forward of the HS it may be easier to actually mount it under the deck. If I did this I can keep the D Sub connector oriented correctly but it woud work best if the unit were inverted (tabs up). Would this allow the compass to function...
Top