Search results

What folders need to be created or files/folders put in of the Seattle Avionics Chart Data for Skyview to see them? SA website provides wrong folders.

Got it. Thanks!

The sensor is standard 1/8 NPT from Aircraft Spruce for fluid temps from 100-350 degrees F. This is what I need for Coolant Temp range. If Dynon temp sensor for Continental O-200 oil temp will read up to 248 degrees F, that would work. Otherwise, is there a way to adjust sensor data file to...

OK. Back to square one. Moved sensor to new GP Pin 11. Set to coolant temp using NPT 1/8 x27. Diagnostics page reads 4.XXXX Volts and a 6.XXXX Value. ?????? How do I get the value reset. I'm still getting a 6 degree reading off the sensor when it should read about 54 degrees F. :-?. Do...

Sorry, I figured it out. I am using Pin9 (Brn/Blu wire). On the 912 setup this pin is pitot temp. Would this have anything to do with it? Otherwise. I'll have to pick another general purpose temp pin that's available or configure one that isn't used.

Dynon Skyview w/EMS updated with current software. Set to Rotax 912 EMS sensors. I had to add the coolant sensor manually to this setup. Using a standard 1/8 x 27 NPT temp sensor in coolant line just outside of pump. Pin number on C37 is...working on getting this.

Installed coolant temp sensor. EMS widget set to Fahrenheit, but value is obviously reading Celsius. What's up with that?

Seems Rotax (Lockwood) is moving towards Datcon pressure senders. Is there any current sensor pin that corresponds to the Datcon electrical match (resistance), common ground sender? I have a 0-80 psi 240-33.5 Ohm, 0-5 bar sender. The other question I have is wiring. There is a single 10-32...