Search results

All, I have been communicating directly with Steve with Dynon Tech support staff (Rev. Case 214111) and can now confirm the following information: 1) On the Rotax 914, Pin 13 from the TCU produces a signal with a Peak-to-Peak reading of ~115 vDC at an operating RPM of around 3000 RPM. 2)...

This past weekend we started a Rotax 914 with electrical hookup as indicated in v13 of Installation manual and copied here: Connect Pin 13 of the TCU to SV-EMS-220 Pin 34 (Low Voltage RPM Left Input). Connect Pin 26 of the TCU to any of Pins 3, 5, 13, 16, 17, or 30 (Ground). Do not install a...

Can anyone advise if the Dynon EMS 220 can accept a 0-5 volt signal that is generated from another device (in my case an ACI Flaps controller running on the aircraft 12 vDC system). The ACI flaps controller we have installed requires a 0-12 Vdc signal for flaps position. I would like to use a...