Search results

Looks like I knocked one of my HS34 knobs and it broke at the shaft. Curious if anyone has dealt with this - and how. Also, if Dynon support is lurking, what would that repair cost me? Thanks!

I've got an EFIS D10A, EMS D10, and HS34.  4 cht, 4 egt, MAP, Red Cube transducer, oil pressure, oil temp, carb heat... The 3 Dynon units are on a DSAB bus that's been working ok for the 20-ish hours since the setup started flying - plus loads of stupid test time.  They are each powered on...

My panel issues seem to be endless. I have an ems-d10, efis-d10a, hs34, edc-d10a. In every incremental installation, everything worked and talked to everything else. I went to finish off the install (no new wiring) and noticed the "remote compass not detected" message. This was new. Yes...

Finally have everything hooked up - an EFIS D10A, EMS D10, and an HS34.  I put power to each component and updated the firmware to the latest version. Once everything was updated, I powered everything up together.  The HS34 adjust baro, etc.  Everything lights up & looks happy.  Then the HS34's...

I have a Dynon packaged Kavlico sensor - Dynon part # 101693-000.  The number stamped on the sensor itself appears to be p4055-5025-6.  Finding info on this has been a bit dodgy and inconsistent. Here's my question.  The sensor it's replacing has a 1/8 npt thread.  The Dynon package claims this...

I bought a used EMS D10. I fear the worst.... * Unit keeps clicking. Is this normal? * What EGT / CHT values should I expect with the DB25 connector removed? There are no thermocouples connected to my unit but the temps jump all over. To troubleshoot, I connected ONLY the +12 and ground...