Search results

  1. R

    power issues.

    Wanted to let you all know that my power issues are fixed and it was entirely my installation error. The ring terminal bringing power to the avionics fuse block was not tightened. Thanks. Ron Voss
  2. R

    power issues.

    Everything was great with my 10A until first engine start today.  The EMS was fine except a negative amp reading, and after a couple minutes I turned on the EFIS.  It powered up and then shut right back down.  Started itself back up and then shut down again.  It did this several times during the...
  3. R

    carb temp

    My bad. You are right. I had the wrong resistor installed. Put the correct one in today and all is good. Thanks. Ron Voss
  4. R

    carb temp

    Just hooked up the carb temp sensor to my EMS and was reading 175 degrees. Instructions called for 1K ohm resistor and 5.5 v circuit being hooked up, but I found a message on this forum that says this isn't used. I unhooked this wire and it dropped to 25 degrees. Temp should have been around...
Top