Search results

  1. E

    SV-GPS-250 not giving position source

    Thanks Kelly - I too checked all the connections - doesn't seem to be that. I should probably try to pick up a used one too.
  2. E

    SV-GPS-250 not giving position source

    Back in July 2020 my SV-GPS-250 started working intermittently. Since then it has stopped working all the time and gives me a "No GPS Position Source" error. I have it set up in serial port 5 as POS 1 and as a SV-GPS-250. I turned the Skyview unit on and measured the following voltages in the...
  3. E

    GPS source failure

    I climbed under the panel and checked all the GPS and Dynon connections. I didn't find anything that looked like a problem, but I did wiggle the connections and tighten the thumb screws on them. I then went flying again (three times actually) with some aerobatics without having a recurrence of...
  4. E

    GPS source failure

    I have been flying the airplane and doing aerobatics for a few years and previously had no problem with the Dynon losing the GPS signal. I also have two other independent gps in the airplane that keep performing while the Dynon loses its signal. Next time I'm at the airport I will go under the...
  5. E

    GPS source failure

    Yes I am well aware of the 6 g limit and I am below the 1375 lbs. For aerobatics it's essentially a one person airplane. One of those potentially dangerous mistakes. I normally try to stay below 4 g. I will check all the connections. What puzzles me is the way the dynon seems to work again...
  6. E

    GPS source failure

    I have an RV-6 with a SV-D700 and a SV-GPS-250 that has worked fine for a few years. The other day I messed up an aerobatics maneuver and pulled close to 6g. The skyview didn't like this and gave me a Skyview GPS source failure. I tried shutting the skyview off and on but the GPS source...
Top