Search results

Sorry for the delay been out of state. I must of had a couple cans of dumb ass, the battery voltage of 13.7 was only a surface charge and as soon as a load was applied the voltage dropped to 8.8. Replaced battery and every thing working as advertised.

I was not using aa power supply and battery voltage was at 13.7 VDC.

I have two 7" sky view screens and am still building, I went to start sky view today and it fired up for approx. five minutes then shut down and started cycling thru the boot cycle and kept going thru the boot cycle. This happens to both screens. Anybody have a clue what causes this

OK when I first started I had a message to test both batteries and there was a yellow battery by the clock on both d-700s. In the set up on #1 battery status was 11.74 volts and the charge status was standby. so I checked #2 and the battery status 12.11 volts and the charge status was charged. I...

Thanks for the above information, I will check the information in the set up when I go to the airport today and get back to you. I don't know about the charging though, the number one D700 is the only one doing it. the number two D700 indicated a solid state charge. Why the difference?

I also have the same problem. I charged both the batteries until the battery status said charged and voltage on #1 was 11.99 and #2 was 12.1 VDC. I ran the test and after five minutes both #1 and #2 shut down. I did notice that the battery on #1 would alternate between charge and standby about...

I think I have found the problem, I don't understand it yet but I had one of the strain reliefs tied into the data shield and as soon as the backshell was installed the 4/8 connection error appeared, disconnect the backshell and the error message goes away. I insulated the shield from the...

I was running version 5 and the hardware is all running on version 6. All the hardward had to be configured manually after the version 6 upload as skyview detected it but everything was in red.

I have two skyview systems and am having problem with a 4/8 connection after loading version 6. I had the same problem earler and the monitors were sent back to Dynon and the problem went away. I'm not sure where the connection problem is because it changes depending on which monitor you do the...