Search results

I too am interested in the com as a stand alone to go along with my D100. I understand that some skyview features would not be available, but it seems that some simple (in my uninformed opinion) software changes would make it usable. You still have supporters of Dynon products who are not...

Just getting back with results. Flew a 200nm cross country with the Garmin wired as above to the D100 and everything performed flawlessly :) I'm making an annunciator panel now to complete the installation (6 diodes and two switches). This will add some flexibility to my panel, which had a...

Jake, That's the perfect solution. I had actually thought about that, but was unsure if the Dynon would have issues with the extra signal on the D9 connector when downloading. I guess this makes sense though, since it is an output. I'll wire it up this way and let you know how successful it...

thanks again Jake.  The reason I asked if it mattered which is that the female D9 connector used to load updates to the Dynon has Pin 22 and Pin 10 connected to it.  If I could use the Dynon serial out (pin 10) to supply the altitude, then I can simply make a male D9 connector with Pins 17 and...

Thanks Jake and Dynon :) Now that I've brought my brand new used 155XL home from my local avionics installer, who gave me a great deal, I have one more question. The 155XL also has an RS232 IN connection, which would allow using the dynon to provide altitude data to the GPS as a backup...

Jake, I did read both of the instructions you referenced. I happen to be a mechanical engineer, and am much less comfortable with electronics. What I was hoping to confirm, after having looked at the two documents, was that I should connect the Channel 1 RS232 output from the Garmin 155Xl to...

Can you instruct me on what to connect to allow the Garmin 155xl to provide input to a D100 in order to use the HSI display on the D100 for the Garmin?  I do not have an HS34, only the D100 and autopilot servos.  I'm thinking I use Pin 24, which is the channel 1 RS232 output.  Other options are...

I'm installing a D100 and the instructions mention using a switched power supply.  The supply is from a 3 amp fuse from the endurance bus.  The e-bus is powered by the master switch.  Is this sufficient for a switch power supply or does the typical installation use a separate toggle switch for...