Hi Everyone,
My Dynon EMS-220 has the J-type probe wires (Red/White) for CHT readings. I've researched and can't find any references online in regards to how the probe is supposed to be connected to the Rotax 914 CHT temp sensor. Do I terminate both wires at the spade terminal , or do I seperate them and ground the negative wire to another location. Appreciate any advice on this subject. Many thanks.
My Dynon EMS-220 has the J-type probe wires (Red/White) for CHT readings. I've researched and can't find any references online in regards to how the probe is supposed to be connected to the Rotax 914 CHT temp sensor. Do I terminate both wires at the spade terminal , or do I seperate them and ground the negative wire to another location. Appreciate any advice on this subject. Many thanks.
you need to connect a wire to the coolant ( head temperature) probe & set up the sensor definitions 