I am currently trying to set up the EFIS to ensure everything works before finalizing my wiring... The NETWORK STATUS page shows the ADAHRS and EMS to be detected and configured. The main screen however has two red crosses showing ADAHRS AND EMS FAIL. I'm also getting a PRES ALT FAIL message. I have run CONFIGURE several times as I learn more...
It seems strange that the devices are detected and configured, but do not show up on the main screen. Before I go to the major exercise of tracing wires and pin-outs, is there something simple I have missed here??
It seems strange that the devices are detected and configured, but do not show up on the main screen. Before I go to the major exercise of tracing wires and pin-outs, is there something simple I have missed here??