I ugraded the D180 wiring to Skyview before it was ever used on my RV12.
I also upgraded Skyview to 3.3.
The ADHRS works after config fine but i do not see an OAT reading.
I converted the wiring to the new system as per instructions and plugged it into the ADAHRS but 0 reading.
Checked and checked but cannot find anything wrong.
When I use an ohmmeter I read about 17 kohm at ambient, which reduces when i heat the sensor. seems to do something.
Is this 17 k normal ?
Am I forgetting to configure something (I cannot find it in the 3.3 manual)
Help is appreciated
I also upgraded Skyview to 3.3.
The ADHRS works after config fine but i do not see an OAT reading.
I converted the wiring to the new system as per instructions and plugged it into the ADAHRS but 0 reading.
Checked and checked but cannot find anything wrong.
When I use an ohmmeter I read about 17 kohm at ambient, which reduces when i heat the sensor. seems to do something.
Is this 17 k normal ?
Am I forgetting to configure something (I cannot find it in the 3.3 manual)
Help is appreciated