AP and Garmin 296 Skyview

[piunocera]

I have the Dynon GPS 250 at the POS 1 and the Garmin 296 at the GPS 1, and i´d like make the AP work engaged with the 296.I tried modify the ports to diferent settings, without success.Can somebody help me to configure the ports to engage the 296 as the head and the 250 as second?

 

[dynonsupport]

First, make sure that when the 296 is turned on, has a GPS lock, and has a waypoint programmed, that the "Good Sentences" on the Dynon display serial port setup for the 296 (under LOCAL DISPLAY SETUP > SERIAL PORT) is incrementing. If it isn't, then make sure that the 296 is set up to output NMEA data at 9600 baud, with the advanced NMEA setup menu data rate setting set to "NORMAL", not "FAST"

 

[piunocera]

Ok,thanks, i´´ll try.

 

[piunocera]

I made sure good sentences, 9600 baud, and fast, but my AP doesn´t works in track mode, just in HDG. Before install 3.0 firmware, i can see GPS 1 and GPS 2 on the screen, but after intall it, the screen didn´t show. Maybe i need do anything eles??

 

[dynonsupport]

You want NORMAL, not fast, on the data rate setting.