skyviewnorge
I love flying!
- Joined
- Jun 20, 2013
- Messages
- 14
Need help because Skyview does not activ AP for calibration. See picture
1. Connected wires from servo to DB9. See attached photo. Has come to the conclusion that this is correct and has double checked. Agreed ?, please see picture (See photo)
2. + 12v Get power from own fuse 5A
3. - Negative, Goes to ground/ bus
4. Yellow wire for Desengage to stick.
5. I have checked that servo recive 12v power.
6. From the 2xServo, DB9 runs to a network,
ADAHRS 200 Goes to network
From network, DB9 cable goes to skyview.
Turning on Skyview enters SETUP MENU> HARDWARE CALIBRATION
As you can see, AP servo calibration is not available.
Is there another place i activate AP servos?
Please get troubleshooting suggestions
See link for picture:
https://www.screencast.com/t/FfeTFg3qfdm
https://www.screencast.com/t/84fo6SCBAA
1. Connected wires from servo to DB9. See attached photo. Has come to the conclusion that this is correct and has double checked. Agreed ?, please see picture (See photo)
2. + 12v Get power from own fuse 5A
3. - Negative, Goes to ground/ bus
4. Yellow wire for Desengage to stick.
5. I have checked that servo recive 12v power.
6. From the 2xServo, DB9 runs to a network,
ADAHRS 200 Goes to network
From network, DB9 cable goes to skyview.
Turning on Skyview enters SETUP MENU> HARDWARE CALIBRATION
As you can see, AP servo calibration is not available.
Is there another place i activate AP servos?
Please get troubleshooting suggestions
See link for picture:
https://www.screencast.com/t/FfeTFg3qfdm
https://www.screencast.com/t/84fo6SCBAA