AP servo firmware mismatch

[lalnaes]

After I upgraded my two 10' screens to 2.6 today, the autopilot stopped working. When I check Network Status, the SV32 labels are marked red with the text "Firmware mismatch". What am I doing wrong? Do the servos need to be powered while I upgrade the screens in order for them be recognized by the system?

 

[schristo]

the servos need to have power during the upgrade or they will not be seen... you can get them to update afterwards by going to the network configuration page in the setup.

 

[lalnaes]

Thanks for the tip, Stephen, I'll give it a try tomorrow.