Dual Skyview screens with knob panel and, autopilot panel. Today after starting engine I noticed that the AP panel ws not functioning. The AP function on the Skyview buttons was missing as well. Trim function is wired through AP panel. Trims works. Checked setup menu for Network devices. AP panel shows up with new V16 update. Status shows Ready and functioning. Setup menu for AP shows servos not installed.Any assistance in trouble shooting this would be greatly appreciated!
Auto Pilot disappears.
- Thread starter pgtuck
- Start date
I suggest you reach out to our support team for more personalized help here (contact info in signature). A few random thoughts:
Are the AP servos not powered for some reason? I'd only expect to see what you're seeing if a SkyView Network configuration was performed with the servos unpowered.
Are the AP servos not powered for some reason? I'd only expect to see what you're seeing if a SkyView Network configuration was performed with the servos unpowered.