I have had my avmap connected to my skyview for a while now, via serial port. I trying to figure out if I have it connected correctly. When I have a destination in the avmap I do get an arrow under GPS1 on the skyview, but I do not get the full hsi...no course deviation needle...I just get an arrow. . Per the manual I believe I should get the full hsi on the skyview. Any ideas?
Avmap Ek IV and HSi
- Thread starter rlallen1
- Start date
So what are all the settings under the serial port that you have it connected to? On that serial port, are you seeing the rx counter increment and good sentences increment too?