beechsport0

[beechsport0]

I had my Dynon EMS D-10 repaired at Dynon Avionics. However, it was sent back to me without the proper settings for my engine and airplane. I need to get the sensor configuration for a Continental 0-200 engine to be used in a 2008 Zenith Zodiac so that my avionics person can reprogram all the settings (fuel pressure, oil temp and pressure, alarms, graphic trim monitor, alarms, etc.) Can anyone send me the sensor configuration? Thanks!

 

[dynonsupport]

So we normally do preserve the setttings, including the redlines and other ranges, that are on units when they come in for repair. however, there are cases, depending on the nature of the failure, when we're unable to back up the memory from the unit. In these cases, you will need to go back through the setup / configuration steps.

As there are lots of different engines out there, and we're not a manufacturer of them, we do not consider ourselves to be sources of operational limits for specific engines. We recommend that you use engine / airframe manufacturer-provided values when available. Of course, in the homebuilt world, this kind information is often available from the community as well, but do be careful.