Caution Message

[moura]

After installed 4.0 I am getting a caution message (green blinking) of "AP BROKEN DISCONNECT" I saw on page 134 of operators manual that Autopilot disconnect switch wire is broken, however the disconnect button is working perfectly. What should I do about it?

 

[dynonsupport]

That means that the enable broken line detect is enabled under the disengage button setup menu, but either the resistor that is needed (see the installation manual for the wiring of that resistor) to detect the broken line is either not installed, or that part of the wiring is broken.

 

[moura]

ok, thank you very much for the input. I will try to disable the broken line detect. Moura