I incorrectly stated that when the HS34 is powered the D10A sees the D120, not so. When the HS34 is powered the two HSIs see only themselves (after configuring each of them). Once the power is removed from the HS34 and the DSAB is configured on the D100 all units (D100, D120 and D10A) appear on the bus except, of course the HS34.
I measured the current draw on the HS34 and it is around 65mA. Also nothing lights up on the HS34 (should there be anything?) and finally my Garmin GNS430 does not connect to the HS34.
Please help.
Thx
Pat
I measured the current draw on the HS34 and it is around 65mA. Also nothing lights up on the HS34 (should there be anything?) and finally my Garmin GNS430 does not connect to the HS34.
Please help.
Thx
Pat