Crimping of pins for manifold pressure sensor

[ZK-LCM]

I am installing a D120 EMS and about to crimp the pins onto the manifold pressure sensor wires.  Unfortunately Dynon do not supply spares so experimenting to get it right is difficult, especially in a small town with limited electronic shops.

Can those of you that have installed these succesfully please tell me whose tool you used and more important which pockets (ABCDE) you used.  I have the B & C BCT-1 & BCT-2 tools and have read Bob Nucklools article but am left very confused as to which tool pocket suits which AWG/Pin combination.

Thank You

 

[Dynon]

If you do end up ruining the pins, give our tech support a call at 425-402-0433 and they can get you spares.