I have a D1000 touch. For the past couple months it has booted with a screen just showing random colored stripes before showing the SkyView logo. Lately it has not been able to boot at all. 1+2+5 resets the unit (screen goes black for a sec) but to the same ultimate result. It's not just the display that's broken because I am not hearing the boot audio either.
The unit was installed in 2016 so likely out of warranty. Waiting to hear back from Dynon about possibly repairing it, but I don't have my hopes up.
Unfortunately I don't know of any D1000T's for sale anywhere so I think I need to upgrade to the HDX or lose touch capability with a Classic. I am thinking of just upgrading to the HDX.
A few questions for the forum (also asked Dynon Support):
1. I have backups of the D1000T configuration. Can I apply these backups to a new HDX installation? Or would I have to enter everything manually?
2. Any hints on extracting these six hex bolts out? I got two out, but the rest are stripped.
3. If/When I’m able to remove this D1000T from my panel, are there some bench top diagnostics that I can perform at home? Or should I just write it off and get a new unit?
The unit was installed in 2016 so likely out of warranty. Waiting to hear back from Dynon about possibly repairing it, but I don't have my hopes up.
Unfortunately I don't know of any D1000T's for sale anywhere so I think I need to upgrade to the HDX or lose touch capability with a Classic. I am thinking of just upgrading to the HDX.
A few questions for the forum (also asked Dynon Support):
1. I have backups of the D1000T configuration. Can I apply these backups to a new HDX installation? Or would I have to enter everything manually?
2. Any hints on extracting these six hex bolts out? I got two out, but the rest are stripped.
3. If/When I’m able to remove this D1000T from my panel, are there some bench top diagnostics that I can perform at home? Or should I just write it off and get a new unit?