Hi
i have a D10A, AP74 and 2x SV32 servo installed, firmware version is 5.6.1
the problem is as follows:
occasionally, the QNH will reset to 1013 and the AP74 becomes unresponsive. this happens with AP both engaged and disengaged. of course if AP is engaged this will trigger a change in altitude.
usually, pushing the AP button several times will reactivate the AP.
i could not identify any special condition for the problem to occur.
any suggestions? thanks.
gmr
i have a D10A, AP74 and 2x SV32 servo installed, firmware version is 5.6.1
the problem is as follows:
occasionally, the QNH will reset to 1013 and the AP74 becomes unresponsive. this happens with AP both engaged and disengaged. of course if AP is engaged this will trigger a change in altitude.
usually, pushing the AP button several times will reactivate the AP.
i could not identify any special condition for the problem to occur.
any suggestions? thanks.
gmr