Hi,
I have a D10A linked to an AP74 and 2 SV32 servo's for roll and pitch.
The system recognises all the components but when pressing the disconnect button to configure the servo's I am expecting another screen to position the controls but nothing happens.
When I turn on the AP switch all the LED's on the the AP74 turn on momentarily before going out. None of the buttons respond upon selection exept the knob which allows ( after a first press ) to set the pressure, the HDG and ALT.
This is a new aircraft to me, the equipt was installed by the pervious owner but not activated ( as far as I know ) so I am a bit lost and any help or suggestions would be most appreciated.
I have a D10A linked to an AP74 and 2 SV32 servo's for roll and pitch.
The system recognises all the components but when pressing the disconnect button to configure the servo's I am expecting another screen to position the controls but nothing happens.
When I turn on the AP switch all the LED's on the the AP74 turn on momentarily before going out. None of the buttons respond upon selection exept the knob which allows ( after a first press ) to set the pressure, the HDG and ALT.
This is a new aircraft to me, the equipt was installed by the pervious owner but not activated ( as far as I know ) so I am a bit lost and any help or suggestions would be most appreciated.