D180 slow to boot?

[rjcthree]

My D180 has been rock solid up until today. Today I hooked up a fixed 13.8v lab power supply (rated to 9a cont., 12a 5sec) to my main bus (still under construction RV9A) and fired up the panel. This is not the same p/s I have used previously. Regardless, the D180 takes minutes (3-4 -5) to go from the blue Dynon screen to operational on the fixed p/s. Using the other supply, it took/takes seconds. I cannot find any issues with voltage/current on my multimeter. Any ideas?

D180 is running 5.2, AP74, one servo. Rick 90432

 

[jakej]

Yes, finish the plane and go flying

Jake J

 

[dynonsupport]

Does the clock tick over slowly and the horizon move way too slowly. I'm guessing the internal clock has failed in some way. If the power supply is really giving 13.8V DC with enough current, it should boot in the normal amount of time. We may need to take a look at that unit.