I need some help trouble shooting a problem. After approximately 50 hours of use, the % horsepower display recently stopped working. The display is now showing ___%. All the other displays appear normal, ie tach, MAP, temp, fuel flow. Any ideas?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
DMS 10 Horse Power %
- Thread starter DickF
- Start date
Re: EMS D10 Horse Power %
I should have mentioned that the GPS connection also seems to be working in that the Gals at wpt and NM/Gal show reasonable values.
However, Idid recently upgrade the GPS from a 396 to a 496.
Thanks for your help
I should have mentioned that the GPS connection also seems to be working in that the Gals at wpt and NM/Gal show reasonable values.
However, Idid recently upgrade the GPS from a 396 to a 496.
Thanks for your help
- Joined
- Mar 23, 2005
- Messages
- 13,226
Re: DMS 10 Horse Power %
Do you have an EFIS from Dynon as well?
If you don't, the thing we need from the GPS is altitude. If it died when you switched from the 396 to the 496, then for some reason we're not getting altitude from your 496. I'd go into the 496 serial output setup and make sure that you have it configured for NMEA out, that you don't have anything odd turned on or off, and that in the advanced menu you have the rate set to "normal" not "fast."
Do you have an EFIS from Dynon as well?
If you don't, the thing we need from the GPS is altitude. If it died when you switched from the 396 to the 496, then for some reason we're not getting altitude from your 496. I'd go into the 496 serial output setup and make sure that you have it configured for NMEA out, that you don't have anything odd turned on or off, and that in the advanced menu you have the rate set to "normal" not "fast."