Doing a Bench Hookup to Power, etc for training?

[falcon]

Can a tech from Dynon please tell us how to power hookup and other inputs that would be a logical way to setup a Skyview display so it can be used for training LSP trainees? We have one mounted in a board and ready to go if we can just get some basic information on wire lead assignments and any other info? We realize simulator mode would not be a reality, but at least we could show the soft button and menus access more easily when not actually in the aircraft.
                             Tom Gilmore, CFII
Working with the Renegade Falcon out of KFPR

 

[Dynon]

Hi Tom,

For a very basic table setup, you can connect an ADAHRS, EMS module, and then power to the red and black wires that go to pins 1&20 (red - power) and 21&22 (black - ground). You'll need to perform a couple of quick configuration steps, as outlined in the "getting started" section in the beginning of the SkyView installation manual (available at http://docs.dynonavionics.com). From there, the SkyView display is essentially usable as a procedures trainer.

If you need a bit more assistance, give our tech support team a call directly at 425-402-0433.

 

[falcon]

Thanks, tech guys. I forwarded your response to Larry Ross at Renegade. We hope to start getting the training activity going at the Ft Pierce operation soon. So far, I really think the Falcon is a great LSA and your SkyView to be an excellent glass panel to fly with!