DSAB: D-180 & EMS D-10

[Legon]

I have the D-180 and all sensors EMS, connected to it.
D-180 has a backup battery.
Is it possible to deduce information about the parameters of the engine on the EMS D-10?
I connected the two devices via DSAB. On the D-10 is only transmitted EFIS-information.
Online shows two devices. On D-180 (EFIS> SETUP> DSAB> STATUS) all parameters (Bus Master, EFIS, OTA[ch8203][ch8203], etc.) are displayed with *. After pressing the DOWN or UP button displays the status of D-10, but parameters (EMC and OAT) without *
Or am I doing something wrong?
Sorry for my english

 

[Dynon]

Unfortunately not. We'd designed the network with the intention that only one EMS would be in a DSAB network, assuming that if one were to get a second unit, it would be an EFIS to gain the redundancy of all of the flight instruments. So if you have a second EMS in the system, it should receive the PFD from the D180, but the EMS will not be usable.