Hello!
Dual 10" SV, pitch and roll servos.
I'd like to have two Disengage/CWS switches--one on each stick, pilot and copilot.
Has this been done? What's the best way? I'd like to preserve broken line detection if at all possible. Would it work to wire the pitch servo's yellow lead to the pilot switch with a 5k ohm resistor across its terminals to ground, and the roll servo's to the copilot's?
Or do I have to splice the two yellow leads together, then connect the combined signal in parallel to the switches?
Thanks for your time!
Dual 10" SV, pitch and roll servos.
I'd like to have two Disengage/CWS switches--one on each stick, pilot and copilot.
Has this been done? What's the best way? I'd like to preserve broken line detection if at all possible. Would it work to wire the pitch servo's yellow lead to the pilot switch with a 5k ohm resistor across its terminals to ground, and the roll servo's to the copilot's?
Or do I have to splice the two yellow leads together, then connect the combined signal in parallel to the switches?
Thanks for your time!