EFIS D10a REMOTE COMPASS NOT DETECTED

[globox95]

Hi
I install my new d10a without edc10a, when i start it for the first time, it said REMOTE COMPASS NOT DETECTED, but i dont install an edc10a and i never connect one.
The firmware was 5.5.0
first, i made the initialisation on the DSAB and it said that i was in stand alone mode, after the initialisation, the message remote compas not detected still again.
i made the firmware update on 5.6.0, during the installation, it tell me that the EDC10 was not connected, sure i dont have one.
I dont make an compas callibration yet. is it the reason of the error message ?
I dont find in the installation manual this situation.

Tanks for HELP
regards

 

[dynonsupport]

You either need to turn the magnetic heading bar off, or calibrate the internal compass. When you calibrate it, it will switch to the internal one.

 

[globox95]

Thank's for your Answer
The D10a seems to be perfect

Best regards

 

[dynonsupport]

As soon as you do the magnetometer calibration, the EFIS-D10A will switch to the internal magnetometer.

In our experience, the internal magnetometer is not reliable in a typical plane's panel - there's too much electrical activity for the internal magnetometer to be able to accurately sense magnetic heading. Thus we always recommend installing the EDC-D10A.

Hi
I install my new d10a without edc10a, when i start it for the first time, it said REMOTE COMPASS NOT DETECTED, but i dont install an edc10a and i never connect one.
The firmware was 5.5.0
first, i made the initialisation on the DSAB and it said that i was in stand alone mode, after the initialisation, the message remote compas not detected still again.
i made the firmware update on 5.6.0, during the installation, it tell me that the EDC10 was not connected, sure i dont have one.
I dont make an compas callibration yet. is it the reason of the error message ?
I dont find in the installation manual this situation.

Tanks for HELP
regards