rlmarshall
New Member
Any plans to support EICAD output from P-Mags? Sure would be nice to have that displayed on Skyview.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
EICAD
- Thread starter rlmarshall
- Start date
- Joined
- Mar 23, 2005
- Messages
- 13,226
No plans at the moment, but that doesn't mean no or never (assuming it's an RS232 output). Just means that it's not currently on the list. It will be a little while before we get around to supporting the vast array of different serial inputs that could potentially be supported, though, since we're still working on things like V1 of the mapping software.
rlmarshall
New Member
Thanks. I understand that EICAD does output to RS232. Good to know that it might show up as a feature one of these days, especially since p-mags are becoming more "standard"