EMS Sensor Mapping question

[bbrocious]

Below is a clip from the EMS Sensor Debug screen. I do not have any fuel sensors, trim sensors or flap sensors.
My questions are these:
1. Are these sensors getting data?
2. Should I change them to "UNUSED"?

P12	FLAPS	POSITION	4094	4.9976	4.998		No Flap sensor available. Is this getting data?
P14	MAIN	FUEL FLOW	0	0	0		No fuel flow sensor. Is this getting data?
P20	LEFT	FUEL LEVEL	4094	4.9976	4.998		No fuel flow sensor. Is this getting data?
P21	RIGHT	FUEL LEVEL	4094	4.9976	4.998		No fuel flow sensor. Is this getting data?

 

[Rhino]

If it says no sensor, there's obviously no data. If you have those sensors available, the system isn’t seeing them. So, again, no data. Only you can determine if they should be set to unused, because only you know what engine you have, what sensors are or are not installed, and whether or not the Skyview should be getting data.

 

[Rhino]

Oh, and do you even have three tanks?