Factory harness pin 16 (black wire)

Battson

Bearhawk
Joined
Aug 16, 2012
Messages
134
I can't find what the black wire on pin 16 of my harness is for, I didn't see it tabulated in the manual. I had labelled it DSAB ground, but I can't find why I did that, there was no instruction about this I could find. Help please
 

dynonsupport

Dynon Technical Support
Staff member
Joined
Mar 23, 2005
Messages
13,226
Sorry we missed you.

As the manual says, this is an "unused ground." It doesn't need to go anywhere. DSAB doesn't need a ground, so you don't need it for that either. You can just remove it from the harness if you don't need it for anything else. It's there as a convenience in case you need a ground (serial, audio, ???).
 
Top