after pulling a few wires for the power and ground on the sykview... flipped the master, programed the power pin in the vp-50, flipped the switch... and the dynon logo came to life. very cool.
with near giddy enthusiasm we looked on.
[ch65532][ch65532]
after a few moments the screen changed to show two large red x’s with ems fail and position fail... hmmm... no network light on the ems module so i unplugged the open ended cable to the adahars, that is not installed, and restarted. okay now we had a network signal but the red x’s persisted.
i could not figure out how to get into setup mode without the book...
press and hold buttons 7 and 8...
enter setup mode, select network configuration, and configure. the dynon finds and registers all devices and sets up the initial screens. wow, this was really cool.
with near giddy enthusiasm we looked on.
[ch65532][ch65532]
after a few moments the screen changed to show two large red x’s with ems fail and position fail... hmmm... no network light on the ems module so i unplugged the open ended cable to the adahars, that is not installed, and restarted. okay now we had a network signal but the red x’s persisted.
i could not figure out how to get into setup mode without the book...
press and hold buttons 7 and 8...
enter setup mode, select network configuration, and configure. the dynon finds and registers all devices and sets up the initial screens. wow, this was really cool.