Flap Indication

[mikemalone]

I have a Skyview 1100 HDX. My flaps are configured through a Vertical Power VPX. I can't figure out how to change the UP setting on the Skyview flap widget to show 'Zero' (0) when the flaps are completely in the UP position. It shows 3 degrees down. I think I managed to fix this before, some time ago, but for the life of me I can't make it read 'Zero" (0) now.

 

[Rhino]

What did you change to lose the previous configuration? Is something new?

 

[jakej]

I have a Skyview 1100 HDX. My flaps are configured through a Vertical Power VPX. I can't figure out how to change the UP setting on the Skyview flap widget to show 'Zero' (0) when the flaps are completely in the UP position. It shows 3 degrees down. I think I managed to fix this before, some time ago, but for the life of me I can't make it read 'Zero" (0) now.

Change that in the Dynon hardware calibration.