Flight level information on Skyview

[Tuiliere]

Hello,

I have a Skyview D1000 recently with the transpondeur SV-XPNDR 26X and it is fine. but with my old transpondeur, I had permanently the Flight level on the display and that was useful because I was not obliged TO change the setting of the altimeter when I flew in flight level. Is it possible TO have this information on the top bar or just below the altitude density information ? I think it is not very difficult TO work out this number for the Skyview.

 

[dynonsupport]

The request here is for a non-baro corrected altitude to be displayed on the SkyView at all times so that you don't need to change the baro to 29.92/1013 when you go to flight levels.

This is not currently possible and is not a request we've had before. We'll consider it if there is more interest.

You can quickly set the BARO in SkyView to 29.92 by holding the BARO knob left or right for two seconds.