Charly
New Member
In my project I have no fuel level sensor installed, but I have a Floscan Transducer system installed.
Do I just miss it or is it just not possible with the DEK180 to have the following fuelcomputer functions:
Given the DEK180 the fuel I have in the tank at engine start should enable it to give me at any time of the flight
1. remaining fuel(including a warning comming up if remaining fuel is going below a predefined value),
2. endurance with current power setting (current fuel flow),
3. total fuel used since installed,
4. average burn per flight hour, etc. etc.
Can you please explain me?
Best regards:
Charly
Do I just miss it or is it just not possible with the DEK180 to have the following fuelcomputer functions:
Given the DEK180 the fuel I have in the tank at engine start should enable it to give me at any time of the flight
1. remaining fuel(including a warning comming up if remaining fuel is going below a predefined value),
2. endurance with current power setting (current fuel flow),
3. total fuel used since installed,
4. average burn per flight hour, etc. etc.
Can you please explain me?
Best regards:
Charly